I don’t know if it’s a simple mistake I’m making setting this up or if i need to buy a replacement.
i followed all the correct instructions from the coralvue video in setup but the motor doesn’t seem to want to turn when the probe is submerged
I took all the electronics out of the system and laid them out. I found that on the blue controller the blue light was constant all the time.
the red light however was different. It would flash on the controller until I took the probe and submerged it (into a glass of water). Once submerged the red light would remain constant
Do you know what’s wrong or which replacement part I should buy?
i followed all the correct instructions from the coralvue video in setup but the motor doesn’t seem to want to turn when the probe is submerged
I took all the electronics out of the system and laid them out. I found that on the blue controller the blue light was constant all the time.
the red light however was different. It would flash on the controller until I took the probe and submerged it (into a glass of water). Once submerged the red light would remain constant
Do you know what’s wrong or which replacement part I should buy?