Large spots in torch flesh???

check out the last posts in my build thread if you want to see what they look like.
 
I had some huge ones lol.. they do blend in very well! I used lugols like 5 times what the bottle said for a few minutes..
 

Attachments

  • 91E170B0-35BB-4AE8-8C7F-B75D89655B34.jpeg
    91E170B0-35BB-4AE8-8C7F-B75D89655B34.jpeg
    112.8 KB · Views: 52
  • 79228CFF-F2C3-4ECD-BAEC-040A7D034834.jpeg
    79228CFF-F2C3-4ECD-BAEC-040A7D034834.jpeg
    115.6 KB · Views: 46
The exact concentration I used is 24oz of water to one cap full of revive. Dipped each one for minimum of 5 min. With in about 20 seconds you will see them peel off.
I’ll give it a shot
Thank you
 
I had some huge ones lol.. they do blend in very well! I used lugols like 5 times what the bottle said for a few minutes..
I found one on the side of my glass one early morning. Thought it was a giant spot of salt creep with no lights at 3am. This suckers the size of a dinner plate! From what I read, when they get this bog, they are euphyillia eating flatworms. Which makes complete sense as prior to finding it, I lost many large colonies of euphyillia(back when they were $10 a head lol).

I've posted this pic a few times over the years. For size comparison, thats a hanger for an MP10 wire on the right side.
20191121_032332.jpg
 
I found one on the side of my glass one early morning. Thought it was a giant spot of salt creep with no lights at 3am. This suckers the size of a dinner plate! From what I read, when they get this bog, they are euphyillia eating flatworms. Which makes complete sense as prior to finding it, I lost many large colonies of euphyillia(back when they were $10 a head lol).

I've posted this pic a few times over the years. For size comparison, thats a hanger for an MP10 wire on the right side.
20191121_032332.jpg
This is the very flatworm I was referring to which is Euphyllia flatworm
1675877307798.png
 
Hey man, I have the same issue with you. Did you figure out anything on this?
 
I would dip it in hydrogen peroxide, 3% for 10 minutes
 

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 9 25.0%
  • Powerheads or wavemakers

    Votes: 3 8.3%
  • Sump or rear filtration chambers

    Votes: 5 13.9%
  • Skimmer or other filtration equipment

    Votes: 2 5.6%
  • Overflow or plumbing

    Votes: 8 22.2%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 8 22.2%
  • Other—tell us what I missed

    Votes: 1 2.8%
Back
Top
Home
Post thread…
Market
What's new