Looking for help with Kalk dosing setup

  • Thread starter Thread starter Jasontkd
  • Start date Start date
  • Tagged users Tagged users None

Jasontkd

Active Member
View Badges
Joined
Sep 23, 2019
Messages
251
Reaction score
54
What state or country do you live in
Kansas
Rating - 0%
0   0   0
I am running a 20 gallon tank. Even with 10-15% water changes weekly, I still need to dose. I have used Kalkwasser in the past, but I am having trouble with it now.

I have limited space for an ATO, and my reservoir holds about 2.5 gallons. I am using a Tunze 3152 for my ATO. Here is my issue. I mix kalk in a separate container and then transfer the limewater to the ATO reservoir. Even with this, I end up with a bunch of settled slurry. I raise my pump off the bottom of the tank to try and keep slurry from being dosed, but every time my ATO pump shuts off, a bunch of water rushes back into the reservoir and the settled kalk is mixed back up.

This doesn't always settle before the ATO runs again. So, I am looking for solutions. BRS recommends just putting the kalk in the reservoir and stirring, but I think I will end up dosing kalk and not just the saturated water.

Do I need a certain sized reservoir to make this work, or is there a solution I am missing?
 
I currently add kalk to my ATO. I use a 20 gallon aquarium for my top off container. When it runs out I take the tank outside and hose it out. I then refill it with fresh rodi water and put the ATO pump in the tank and make sure there are not any air bubbles in the pump. I built a small stand for the pump out of egg crate to keep the pump about 1 1/2" off the bottom. I then measure out my kalk powder into a container. I have a long stainless kitchen spoon that I use for my mixing. I then start to stir the water as I add the kalk powder quickly. I just stir long enough to get it mixed, usually maybe 5 or 6 seconds. I then place the cover on and let it settle. My cover is a plastic aquarium cover and fits flush into the top edge of the tank and I have a strip of gorilla tape around the edges to give a good seal and help to limit air getting in and limiting evaporation. To give it time to clear up, I add about 3 or 4 cups of rodi to my sump to give the pump about 5-6 hours before the evaporation gets to the level where the pump kicks on. This has worked well for me. Hope this helps!

15856933597651717795429768406639.jpg 15856933764615153495386144949136.jpg
 

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 19 27.9%
  • I’d trust someone who knows my tank to choose

    Votes: 2 2.9%
  • I’d rather get a gift card and pick it myself

    Votes: 26 38.2%
  • I’d prefer gear or supplies instead

    Votes: 2 2.9%
  • Please don’t surprise me with livestock

    Votes: 19 27.9%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new