Low salinity first week of tank cycle!

  • Thread starter Thread starter Eggpaul
  • Start date Start date
  • Tagged users Tagged users None

Eggpaul

Well-Known Member
View Badges
Joined
Feb 15, 2018
Messages
517
Reaction score
247
What state or country do you live in
California
Rating - 0%
0   0   0
150 gallon tank- 125 lbs of dead rock, 30 lbs of live rock, 80 lbs of live sand.

It has been 7 days since I added water and yesterday I noticed salinity was very low. It is at 1.010. Currently adding salt. got it up to 1.015 yesterday.

Question. Do you think the bacteria in the rock and sand survived this? Temperature was 79. Should I drop a few food pellets in there? Or a shrimp to help out?
 
I think you’re fine.
If your doing a fishless with ammoina you could redose , but check the ammoina and go from there. Some ghost feedingis fine too.
 
I think you’re fine.
If your doing a fishless with ammoina you could redose , but check the ammoina and go from there. Some ghost feedingis fine too.


Ammonia was zero last night. I'll add a frozen shrimp today. Is that more effective than pellets?
 
You're fine!

Don't worry about it. Just slowly raise it up to where you want it to be.
 
Ammonia was zero last night. I'll add a frozen shrimp today. Is that more effective than pellets?
Either way really. It’s a mostly live tank right now. Just needs some food.
 
Add salt slowly in the sump and keep mixing. With no fish or corals this is safe to do.
 
Add salt slowly in the sump and keep mixing. With no fish or corals this is safe to do.
Can't just add in the display since I have no fish?
 
Can't just add in the display since I have no fish?

Yes, but if you have sand it can make mixing difficult. Sump would be better. If you have no sump then I would fill a 5 gallon bucket half way and add salt. Mix and pour. Keep doing that until you hit .020. From there you can add salt water for your top off until you’re in the .023-.026 range.

If you use the bucket method don’t let it go over .030 or it may precipitate.
 
Yes, but if you have sand it can make mixing difficult. Sump would be better. If you have no sump then I would fill a 5 gallon bucket half way and add salt. Mix and pour. Keep doing that until you hit .020. From there you can add salt water for your top off until you’re in the .023-.026 range.

If you use the bucket method don’t let it go over .030 or it may precipitate.
Okay, I will do that. I added quite a bit yesterday in the display and it hardly went up. I feel like some settled on the sand. Will it eventually dissolve??
 
Okay, I will do that. I added quite a bit yesterday in the display and it hardly went up. I feel like some settled on the sand. Will it eventually dissolve??

Eventually it will. It’s okay for you to stir up the top layer of sand since it’s empty and there’s nothing bad in the sand yet
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 14 17.5%
  • Fish or coral food

    Votes: 5 6.3%
  • Test kits or reagents

    Votes: 8 10.0%
  • Filter media or replacement fleece

    Votes: 4 5.0%
  • RO/DI filters or supplies

    Votes: 13 16.3%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 9 11.3%
  • I keep a backup of everything

    Votes: 21 26.3%
  • Other (Post in the comments)

    Votes: 6 7.5%
Back
Top
Home
Post thread…
Market
What's new