Maxspect gyre xf250s with advanced controller settings help

[Cody Clark]

Basically I want pump a to start ramping up from 0 to 100% over 10 minutes while pump b ramps down from 100 to 0% over 10 minutes. Then the pump at max holds for 10 minutes and the pump at 0% stays off and then they alternate as the one at 0% ramps to 100% over 10 minutes and the one at 100% ramps down to 0%. From there just repeat over and over all day long. I thought i somewhat figured it out but not for that extended period

 

[EmdeReef]

I followed this blog and basically set up something similar to what you are looking for:

https://blog.coralvue.com/maxspect-gyre-200-series-advanced-controller-setup/

You will want to switch to manual mode, enter ramp up and down time on pump A and power. Once complete select the second pump and pick antisync as the mode and then select timing. I don’t recall What’s the longest time setting but think there was a 10min option.