Media reactor

  • Thread starter Thread starter bkhunt
  • Start date Start date
  • Tagged users Tagged users None

bkhunt

Well-Known Member
View Badges
Joined
Sep 30, 2012
Messages
795
Reaction score
239
Location
Pittsburgh, PA
Rating - 100%
1   0   0
I setup a phosban reactor with Dr Tim pellets and hit was running perfect for a few days with me Jebao dc4000 pump at 7/10 power switched from smaller pump since I added more pellets. There is about 1 cup of pellets in the reactor have been building up over last month or so. Last night I noticed the pellets had stopped moving and bumped up to 10/10 and turned reactor over to move pellets and that did not make them move. I swapped out pump to an old mag 5 that I had sitting there and got very little movement of pellets. So my question is do these become “water logged” or “sticky” after being in the water? Should I remove some pellets as I should need 1.5ish cups for my tank?
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new