Meridian - Hanging Wires

[BrokenReefer]

Have you had any feedback on the hangars slipping? I got the light hung yesterday and each one of the “clips” has slipped at least 1”

 

[Reef Breeders Verified Sponsor]

Hey There!

I have not- the cables are quite strong. How did you loosen them to begin with? The top has a push tab where the wire comes out to release it.

 

[BrokenReefer]

I loosened the screw on the bottom to adjust the center; tightened, then adjust with the spring on top. Same setup at the Orphek light I had, so it was familiar (if not a little easier with the coating).

 

[SpSDrew]

Mine shifted on one side a tad and took some messing around with to get it to “lock in”.

 

[Zuluuz]

Have you had any feedback on the hangars slipping? I got the light hung yesterday and each one of the “clips” has slipped at least 1”

Have you had any issues with the wire mount shifting laterally? Trying to figure out how to keep them from sliding along the rails

 

[BrokenReefer]

Have you had any feedback on the hangars slipping? I got the light hung yesterday and each one of the “clips” has slipped at least 1”

Have you had any issues with the wire mount shifting laterally? Trying to figure out how to keep them from sliding along the rails

Not from the wire hanging out, I have two of the Edge bars and those slide on the rails but that doesn’t concern me too much.

I am working on a new system to mount the lights to that will allow me to raise and lower the fixture with a pivot point.