Hi,
I am going to finally plumb my Saltwater Mixing station and would definitely appreciate some tips as this is my first attempt at plumbing anything and the wife would likely not appreciate to have 110 gallons of water in the floor of the laundry room .
I have two "Norwesco" type 55 gallons graduated cylinder shaped deposits (which were expensive as hell!!!). My main question (fr now) is if a bulkhead will make a tight enough seal in the rounded part of the barrel... I have seen a number of people doing it (including with Brute trashcans) so I guess it should work, but would like to be sure before I ruin (I mean drill) these expensive deposits.
Also, any tips would be greatly appreciated.
Kind regards
I am going to finally plumb my Saltwater Mixing station and would definitely appreciate some tips as this is my first attempt at plumbing anything and the wife would likely not appreciate to have 110 gallons of water in the floor of the laundry room .
I have two "Norwesco" type 55 gallons graduated cylinder shaped deposits (which were expensive as hell!!!). My main question (fr now) is if a bulkhead will make a tight enough seal in the rounded part of the barrel... I have seen a number of people doing it (including with Brute trashcans) so I guess it should work, but would like to be sure before I ruin (I mean drill) these expensive deposits.
Also, any tips would be greatly appreciated.
Kind regards