Moisture trap for recirculating scrubber

Court_Appointed_Hypeman

Valuable Member
View Badges
Joined
Sep 15, 2022
Messages
1,275
Reaction score
784
Location
Loves Park
Rating - 0%
0   0   0
Any recommendations on a moisture trap for the airline on a recirculating CO2 scrubber?

This would be perfect if I could get barbed 1/2 fittings on it.

Hydronix HX-HF3-5CLWH12 5" Housing Rib Cap for RO & Filtration Systems, 1/2" Ports, 1 Count (Pack of 1), Clear/White https://a.co/d/atSzw8S

Its the right size, but can go smaller.

Right now I am using a copepod jar I glued barbed fittings onto, but I think when I handle it the seals crack some and I can't be sure when I seal it back up its not leaking air.

Currently my skimmer lid doesn't form a vacuum the way it would prior so I assume it's not sealing anylonger.
 
I do get a lot of moisture from bubbles that will not pop from carbon dosing, I am not sure those fittings will hold up. But its a good consideration.
I would NEVER use a brass fitting near a saltwater tank, my eyes fell to the dessicant packs, slim design, and drain on the bottom.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new