MORE APEX HELP NEEDED

[CHIEF_OF_THE_REEF]

I got my new EB4 and I am trying to get my heaters to run off it. I can turn it on and off no issues, but when i try and program it, it just stays on unless i take the slider to switch it to off. I have copied and pasted the exact code as my 1st heater, and i also tried using the default settings for the heater. no joy. it just stays on unless i change it manually. here is the code..


Fallback OFF

If Tmp < 78.1 Then ON

If Tmp > 78.9 Then OFF

my current temp is 78.4. please help me

 

[SuncrestReef]

Are you setting the slider to AUTO? Do not set the slider to ON because the programming only runs when set to AUTO.

 

[CHIEF_OF_THE_REEF]

yes the slider is in auto, and it still shows as on. i am confused

 

[CHIEF_OF_THE_REEF]

Here is a screen shot

 

[CHIEF_OF_THE_REEF]

And then here, where it says heater2

 

[jabeuy]

If your current temp is 78.4, it wont turn off until it goes above 78.9

 

[CHIEF_OF_THE_REEF]

ok, so then i need to turn the other heater on to get to temp then, i guess that would make sense. I will give that a go

 

[CHIEF_OF_THE_REEF]

that was exactly the issue, thank you very much!