MP40 Antisync not working properly

[teethdoctor23]

My MP40s aren’t performing like they should. I have one as the “parent” the other is the “child”, and they’re on anti sync, however they are ramping up and down on reef crest mode at the same time, instead of working properly.

Has anybody encountered this and possibly know a fix? TIA

 

[Lavey29]

Did you program via mobius?

 

[teethdoctor23]

Did you program via mobius?

Yes I did

 

[Lavey29]

Yes I did

And as you look at the front page of mobius does it show both your pawerheads in window shortcuts? Can you see the changing GPH of both? They are identical?

 

[teethdoctor23]

And as you look at the front page of mobius does it show both your pawerheads in window shortcuts? Can you see the changing GPH of both? They are identical?

Yes they are identical, ramping up and down at almost the same exact time instead of running opposite on the antisync

 

[Lavey29]

Yes they are identical, ramping up and down at almost the same exact time instead of running opposite on the antisync

Hhmmm, have you tried removing the child and then adding it back?

 

[teethdoctor23]

Hhmmm, have you tried removing the child and then adding it back?

Yes I have, do you have Mobius using MPXX with antisync and it works properly?

 

[Lavey29]

Here is the manual method. Did you buy these new or used? If used it says you need to clear the memory before master slave can be set up.

https://support.ecotechmarine.com/hc/en-us/articles/206231128-VorTech-Configuring-Parent-Child

 

[Lavey29]

Yes I have, do you have Mobius using MPXX with antisync and it works properly?

Yes. Been working fine 2.5 years

 

[teethdoctor23]

Here is the manual method. Did you buy these new or used? If used it says you need to clear the memory before master slave can be set up.

https://support.ecotechmarine.com/hc/en-us/articles/206231128-VorTech-Configuring-Parent-Child

Mine are brand new

 

[teethdoctor23]

Yes. Been working fine 2.5 years

The problem with the manual mode is I don’t see a way to do the antisync setting

 

[Lavey29]

The problem with the manual mode is I don’t see a way to do the antisync setting

Ok I would still do the clear driver memory and start over with mobius then

 

[Lavey29]

I just watched both pumps GPH for about 2 minutes. It went from 200gph to about 550ghp difference up and down both sides. That's all the anti sync was.