MP60 loud vibration noise, tricks to getting quiet?

Prevailing Reef

Valuable Member
View Badges
Joined
Nov 24, 2014
Messages
1,336
Reaction score
1,065
Location
California
Rating - 0%
0   0   0
I’ve never used Ecotech Vortechs before.

I got two new MP60s and turned them on for the first time.

They were making a really loud vibration/grinding noise at first until I started moving the motor around to aline the wet side up better. I got the noise level down but it is still more noisy than I was expecting depending on the power level.

The glass I have it mounted on is 3/4 and painted.

Any tricks to getting these things quiet?
 
I've noticed a considerable reduction in noise after running my MP40 for a few weeks. The break in period is real.

That said, if I crank mine up to 100% there's still a pretty audible hum. Running it around 50% in a 32" tank and it's barely audible from 5 feet away unless I really listen for it.
 
if they're anything like the MP10's the alignment is super sensitive. something like a 1/8-1/16'th off is the difference between quiet and noisy.
If you can crank it up to full when you align it. makes it easier to find the sweet spot IMO.
also read the directions about the spacers, i;m not sure which is required when, but i know that they make a difference also.
 
You have to align them by feel because of the diffraction of the glass
 
First, make sure you are using the correct spacer. Then with the motor off, rotate the wetside in place until it feels like it 'catches'. Then start the motor, put your hand on the dryside and make small adjustments with the wetside position until the dryside vibrations are minimized. I did not personally ever observe a 'break in' period for these pumps, though over time they will tend to self align so perhaps that is what some ascribe to a break in period. The MP60 should be quiet but it is not silent.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new