Hello.
I got my Apex all up and running and I have a Breakout Box. I bought this to serve the purpose of letting me know if my sump is to high or to low, as well as I wanted to put a sensor in my ATO container so the Apex will text me when it's low and one for when it's full and do the same for my salt water mix container. They are 44 gal Brute trash cans so I need sensors that can be submerged and have a long enough wire on them to be at the bottom of the container and then reach the Breakout box. I'm thinking like 6-8ft of wire. I've seen you can buy like packs of 5 float sensors. I'm just not sure if I should go with these. If the wire will be long enough, and how I would even mount them in the Brute can at or near the bottom. Looking for any and all suggestions. Thanks
I got my Apex all up and running and I have a Breakout Box. I bought this to serve the purpose of letting me know if my sump is to high or to low, as well as I wanted to put a sensor in my ATO container so the Apex will text me when it's low and one for when it's full and do the same for my salt water mix container. They are 44 gal Brute trash cans so I need sensors that can be submerged and have a long enough wire on them to be at the bottom of the container and then reach the Breakout box. I'm thinking like 6-8ft of wire. I've seen you can buy like packs of 5 float sensors. I'm just not sure if I should go with these. If the wire will be long enough, and how I would even mount them in the Brute can at or near the bottom. Looking for any and all suggestions. Thanks