Need some help woth my Apex Jr.

[LeafsReefer]

This is my first Apex product, so I'm having trouble setting up the water level sensor that comes with the Apex Jr. I'm getting notifications on my phone, but can't figure out how to get notifications from the level sensor that I put on my ATO resovoir. I can see it switch to close when I filled it with water, but I couldn't get a notification. I tried to setup notification when it went to closed as a test. ALARM_2_2 is On and in configuration I have

Set ON
If ResLow CLOSED Then ON

EMAILALM_I5 is on and has

Set ON
If Swx1_1 CLOSED Then ON
If ResLow CLOSED Then ON

ResLow is the level sensor amd Swx1_1 is the leak detector on the floor.

Also, the notifications show that module FMM_2 is missing. Doesn't the Jr. only have 1 FMM port? Can I just delete it?

 

[tzabor10]

There is an apex forum. I struggle with the programming aspect

 

[LeafsReefer]

Thanks, I'll try there.

 

[c0kefree]

Should be ‘Set OFF’

I see nothing else wrong.

Apex jr has 2 FMM ports. Both mono jacks are “fmm” ports.