Need some help

[Slickreece]

Ok guys I need help. I have 3 AI vega light fixtures the controller that was given to me with the does not have a face plate. What can I use for the keypad to make it work

 

[Brew12]

Are the internals of the buttons missing, also? If so, that becomes much more challenging. You may be better off buying a new one.

 

[Slickreece]

Are the internals of the buttons missing, also? If so, that becomes much more challenging. You may be better off buying a new one.

What I have is what you see in the picture as far as the controller

 

[Brew12]

What I have is what you see in the picture as far as the controller

I can't tell from the picture if the button operators are under the tan wafers or if they are just missing. If they are missing you can buy new ones and solder them in if we can figure out where the wires used to go.

 

[Slickreece]

I can't tell from the picture if the button operators are under the tan wafers or if they are just missing. If they are missing you can buy new ones and solder them in if we can figure out where the wires used to go.

What would it look like

 

[Brew12]

What would it look like

If you push on the tan squares, do the click?

 

[Slickreece]

If you push on the tan squares, do the click?

No

 

[Brew12]

No

Then someone scavenged the buttons off the units. It will be a challenge to make it work. Not only would you have to find and solder in new micro switches, but you would need to figure out where the wires for each switch went.