Neptune Apex PH calibration question

what do you mean by manual mode and twice?
Go into the probe and you will see the manual mode and temp correction. Use tc and manual. After I calibrate once I just go ahead and do it again and it's way more accurate.
Float the 7 and 10 in tank to warm it up.
 
Last edited:
Here are directions

Screenshot_20230606_130527_APEXFusion.jpg Screenshot_20230606_130553_APEXFusion.jpg Screenshot_20230606_130615_APEXFusion.jpg Screenshot_20230606_130638_APEXFusion.jpg Screenshot_20230606_130712_APEXFusion.jpg
 
I don't like the way they do the calibration these days.
You have to wait until it's stable for a few seconds then proceed.
What I do is float the 7 and 10 in my sump.
Dry probe off on paper towel.
Put in 7,wait until stable. Next.
Swish in rodi, dry on towel, put in 10 until stable, finish button. Swish in rodi, put in tank.
Then, do it all over again. For some reason I get better results, faster results, the second time around. I think it's the software they use.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new