Neptune DOS Manual Water change

[drjr1861]

I recently hooked up the Neptune DOS and wanted to use the manual water change function through the set up wizard. Everything seemed to work fine through the set up, the virtual outlets were created, I didn't alter them, everything set to AUTO. The issue i ran into was that about 5 or so minutes after finishing the set up process the pumps initiated and started adding/removing water. I didn't push the feed mode button that i had designated or select the water change option at the end of the set up.

I think my best workaround is to use the DoW function to set the DOS to off on all the days except for the day i want the change to take place but i was wondering if anyone had a similar issue with the manual water change function and if there is a fix.

 

[Reefing Madness]

 

[dangles]

If you don’t get your question answered here, I’d suggest trying Neptune support forums. They usually do a good job helping with these kinds of things.

 

[BrokenReefer]

Please post your schedule or any code that you may have added.

 

[Bartanto]

So the task created H2O_start and H2O_control? Would like to see code on both pls! I’d also just run the task again to overwrite whatever you have now.