- Joined
- Jun 8, 2018
- Messages
- 1,158
- Reaction score
- 649
Ok I installed my DOS, part of the setup was to measure you lines, but I do not understand why, they say to caluate the amount of fluid in the line to get a correct dose. For example if the line holds 5 mls an you want to dose 30 mls, then u program a 35 ml dose. I get that. however. That only applies if your lines are not primed/ empty at the being of the dose right?
I looked at my lines this morning, pre dose, an they are still primed. So why add the line volume to the dose amount if your lines stay primed?
I looked at my lines this morning, pre dose, an they are still primed. So why add the line volume to the dose amount if your lines stay primed?