New Red Sea Reefer S100

[Keepswiming]

Thought I would share my Xmas gift to myself.

I am very impressed with the build quality and fit and finish of these new Red Sea tanks!

 

[Real McCoy]

I just did the same.Xmas gift to myself as well.Upgrading my 300XL to a 850G2.I look forward to seeing more of your tank and the live stock you add to it. Like the rock lay out.

 

[infysucks]

Hello reefer, kindly help me in figuring out what screw connector has been used for this connection and if it comes as a pre-loaded hardware attached to the vertical Front Support profile. If you could share a close-up picture of the attachment from inside the sump, it will be really helpfull.
1. Unable to understand how the Front Support vertical profile with the pre-installed end cap/plate connector (not sure) on its top end, supports the Top Centre Frame profile, without an end to end connection.
2. How this screw is connected to the Top Centre Profile. Is there any access hole drilled in the Top Centre profile where the head of this screw connector sits after lining it up with the vertical Front Support profile.
3. How to disengage and pull out the vertical Front Support connected profile from the Top Centre Frame profile, using a hex wrench by loosening the internal screw, rather than sliding it out from the end, when its time to take the sump out for periodic maintainence.
4. Is this a telescopic screw or a clamping ball with cup screw