- Joined
- May 22, 2019
- Messages
- 49
- Reaction score
- 13
Hi,
Having a little trouble setting up a used ATK. My optical sensors are always reading open and they do not change regardless of being in or out of water.
FMM firmware updated - yes
Optical sensor wires plugged in and seated into FMM ports 1 and 2 - check
Under FMM configuration I am on auto detect/ Optical for both ports 1 and 2.
My FMM is connected via aquabus to my eb832.
My pump gets power from one of my 24V outlets on the eb832.
I can tun the port on and off via apex. The PMUP pump is always on ( unless I shut it off) because it thinks by sump is low.
Question - I do not have a 24 power supply connected to the FMM, does the FMM get power for the optical sensors through the aquabus?
Thanks!
(Here is my code
Fallback OFF
Set OFF
If Swx3_1 OPEN Then ON
If Swx3_2 CLOSED Then OFF
When On > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 000:01 Then OFF
Having a little trouble setting up a used ATK. My optical sensors are always reading open and they do not change regardless of being in or out of water.
FMM firmware updated - yes
Optical sensor wires plugged in and seated into FMM ports 1 and 2 - check
Under FMM configuration I am on auto detect/ Optical for both ports 1 and 2.
My FMM is connected via aquabus to my eb832.
My pump gets power from one of my 24V outlets on the eb832.
I can tun the port on and off via apex. The PMUP pump is always on ( unless I shut it off) because it thinks by sump is low.
Question - I do not have a 24 power supply connected to the FMM, does the FMM get power for the optical sensors through the aquabus?
Thanks!
(Here is my code
Fallback OFF
Set OFF
If Swx3_1 OPEN Then ON
If Swx3_2 CLOSED Then OFF
When On > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 000:01 Then OFF