Hi Steve, is there any particular information I can give you on the lights? If you would like to buy, please send me your shipping address and a contact phone number to [email protected]
Orphek OR4 bars
- Thread starter Jackd1023
- Start date
- Tagged users None
Yes, they weight 7.5 lbs, all aluminum housing.
steve 1965
Active Member
Ok I currently have a OR3 blue plus how much does the Or3 weigh? I do have that hanging off my Red Sea brackets with no issues.
Also the new OR4s using the app. Can you also program different channels to be brighter or lower than others ?
Also the new OR4s using the app. Can you also program different channels to be brighter or lower than others ?
The OR3 and 4 are very close to being the same weight. You did not state the length of your light so I cannot give you an exact figure. OR4 lights have only one channel so programming, intensity, etc are controlled. For a complete list of features, go to www.orphek.com and click on producs.
steve 1965
Active Member
I’m sorry it’s 60”.
steve 1965
Active Member
The 60” lights are 150cm is that the total wattage at 100%?
steve 1965
Active Member
Nevermind it’s centimeters duh. What’s the total wattage?
For a OR3-150 (60"), it weighs 7.5 lbs, Tom.
LobsterOfJustice
Valuable Member
Anyone have updates, thoughts, insights on this?
Actually the OR4 blue plus should appear brighter to our eyes because the intensity in the upper range of the spectrum will appear brighter. Our eyes do not see intensity changes too well in the area between 400 and 450nm. With this being said, the only true way to measure intensity in this low area of the spectrum is with a quality PAR meter.
steve 1965
Active Member
Which model, the Atlantik Icon or Natura Icon?Hi what spectrum are the orange and the black lines on the left?
Michelle G
Community Member
- Joined
- Nov 16, 2015
- Messages
- 39
- Reaction score
- 15
Are these bars supplemental lighting?
Bobby daniels
Well-Known Member
- Joined
- Oct 8, 2017
- Messages
- 565
- Reaction score
- 108
That's what most use them for, but our torch growout uses nothing but or4's. And it's a bug time producer for us
Michelle G
Community Member
- Joined
- Nov 16, 2015
- Messages
- 39
- Reaction score
- 15
I am considering ordering one to supplement my xr30.
DThe bars can be used as supplemental lighting but many use them for whole tank lighting. The OR4's use the same LEDs as our flagship models. For faster service, you can contact me at [email protected].
backbayreef
2500 Club Member
I have both the OR3 UV/Ultra Violet (36” and 48”) and the equivalent OR4 lights on a 8ft tank. Per my naked eyes, the OR3 is much brighter! Anything I can do?Actually the OR4 blue plus should appear brighter to our eyes because the intensity in the upper range of the spectrum will appear brighter. Our eyes do not see intensity changes too well in the area between 400 and 450nm. With this being said, the only true way to measure intensity in this low area of the spectrum is with a quality PAR meter.
Honestly I’m not very happy with my setup either. I should have saved some $$ and use Radions as primary lights and Orphek as accent lighting?
Good luck with yours.
Michelle G
Community Member
- Joined
- Nov 16, 2015
- Messages
- 39
- Reaction score
- 15
I just ordered the OR4 iCon Blue Plus 36" bars I will try one and see how I like them, I do have a spectrometer so I am going to look at the spectra before and after adding the light. My primary light is a Radion XR30 g6 pro over my 47 gallon AIO tank.DThe bars can be used as supplemental lighting but many use them for whole tank lighting. The OR4's use the same LEDs as our flagship models. For faster service, you can contact me at [email protected].
Sounds good.
Similar threads
