overflow height

[vcnt]

How tall should I order them? My overflows was damaged by PO, so i need new pair.

 

[vcnt]

bump

 

[The Farmer]

Is your tank pre drilled for overflows?

 

[vcnt]

Is your tank pre drilled for overflows?

Yeah in the bottom i just needed to replace since PO put like weird ahh holes in them

 

[The Farmer]

where the previous overflows cut down? if not, why not measure them.

 

[UncommonSense]

How tall should I order them? My overflows was damaged by PO, so i need new pair.

What style of overflows?

 

[vcnt]

where the previous overflows cut down? if not, why not measure them.

was thrown out, i might just see how much shorter they are, relative to rim, in my other tank and order to that measurement

What style of overflows?

like these

 

[UncommonSense]

was thrown out, i might just see how much shorter they are, relative to rim, in my other tank and order to that measurement

like these

I actually just installed a quarter-cylinder overflow which terminated exactly 1/4” below the tank’s plastic rim….

The teeth height in the overflow will dictate the tank’s operating water height (water will pack up, and be ~1/4” above the bottom rim of each tooth), so plan accordingly off that more than anything!

 

[The Farmer]

The teeth height is normally 1” - 1 1/2”. If I’m not mistaken.