Overriding stream values

[Macca_75]

Hey all. I currently have my 4 DC pumps 1-10v input being controlled by my P3. I also have a PL-ADIN card.
Is there a way to use one of the push buttons to create a 5 minute timer to run all of the streams I want at 100%. I don't want to add the 5th DC pump as it's my return so I would need to be able select which stream groups to respond to this.
Idea being I would push the button and then give the Rockford a gentle blast with a small pump or turkey baster to loosen detritus into the water colum.
Thanks in Advance.

 

[Lasse]

Yes it is - with help of a maintenance function and the 1-10 V overrun of actual maintenance function

Or - finally - get a P4 and use some of the options with the new pump programming interface:)

Sincerely Lasse

 

[Macca_75]

Yes it is - with help of a maintenance function and the 1-10 V overrun of actual maintenance function

Or - finally - get a P4 and use some of the options with the new pump programming interface:)

Sincerely Lasse

Thanks @Lasse - Perfect - figured it out with a Maint mode while keeping the other "button" as feed mode.

Does the P4 have a mode to run all streams (that you choose to put into scope) at 100% for a timed period? That could be tied to a maint mode or similar?

 

[Lasse]

O yes

Here is one of my schedules for my streamers that are controlled by my profilux (Versia stream plus another)

At 12 and around 16:30 all pumps in this setup run 100 % (red markings. Blue markings (matning) is a program that initiates of my maintenance 1

Red markings (show it in GCC because you see it better in that application

Blue marking

You can activate a pump program through time interval, timer, switch channel, maintenance or feed pause

Get that P4 :) :) ;)

Sincerely Lasse