PAB Communication with power loss

  • Thread starter Thread starter KStatefan
  • Start date Start date
  • Tagged users Tagged users None

KStatefan

5000 Club Member
View Badges
Joined
Jun 24, 2015
Messages
5,596
Reaction score
5,023
Location
MHK
Rating - 0%
0   0   0
Reviewing my power system now and have a question. If I have a chain of powerbars hooked up to my P4 and one of them loses power will the communication to anything down stream also lose communication?
 
Yep - you will have communication with the units between the P4 and the powerless unit - not after the faulty unit. Therefore - its good to have a RJ45 coupler (CAT5 or 6) at home - you use that to connect incoming and outgoing PAB cable from the faulty device.

1707327475982.png


Sincerely Lasse
 
Though I had a better power outage plan then I actually did. Each power bar was on a separate circuit but cable connecting them. I think I will rewire them so they are both first then go to dosing pumps.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new