Parameters look off

Jayreef23

Community Member
View Badges
Joined
Nov 18, 2019
Messages
95
Reaction score
24
Rating - 0%
0   0   0
So things in my tank weren’t looking too good so I got my water tested at my LFS
This is the results:
500 Calcium
7 Alkalinity
5.0 Nitrate
0.5 Phospate
7.4 PH
1.030 Salinity

what should I do?
 

attiland

2500 Club Member
View Badges
Joined
Jul 22, 2020
Messages
2,594
Reaction score
4,800
Location
United Kingdom
Rating - 0%
0   0   0
So things in my tank weren’t looking too good so I got my water tested at my LFS
This is the results:
500 Calcium
7 Alkalinity
5.0 Nitrate
0.5 Phospate
7.4 PH
1.030 Salinity

what should I do?
Calcium seems to be high alkalinity low. I would check magnesium too based on this. My bet that it is off too.
depending of the age of your tank probably I would do some water changes to correct it.
Do you dose anything?
 
OP
OP
J

Jayreef23

Community Member
View Badges
Joined
Nov 18, 2019
Messages
95
Reaction score
24
Rating - 0%
0   0   0
Calcium seems to be high alkalinity low. I would check magnesium too based on this. My bet that it is off too.
depending of the age of your tank probably I would do some water changes to correct it.
Do you dose anything?
I dose Calcium and Alkalinity and Red Sea Reef Energy
 

attiland

2500 Club Member
View Badges
Joined
Jul 22, 2020
Messages
2,594
Reaction score
4,800
Location
United Kingdom
Rating - 0%
0   0   0
I dose Calcium and Alkalinity and Red Sea Reef Energy
Well you have to tune this a bit then. Less calcium ideal between 350-450ppm and alkalinity should be 8-9dkh
Alkalinity drops if magnesium is off. It should be 1200-1350ppm.

also high calcium drops alkalinity too
 
Last edited:
OP
OP
J

Jayreef23

Community Member
View Badges
Joined
Nov 18, 2019
Messages
95
Reaction score
24
Rating - 0%
0   0   0
Well you have to tune this a bit then. Less calcium ideal between 350-450ppm and alkalinity should be 8-9dkh
Alkalinity drops if magnesium is off. It should be 1200-1350ppm.

also high calcium drops alkalinity too
Alright Thanks I’ll try to fix it
 

Dkmoo

Valuable Member
View Badges
Joined
Nov 30, 2020
Messages
1,590
Reaction score
1,979
Location
Nyc
Rating - 0%
0   0   0
pH is in the danger zone - 7.7 should be your lowest acceptable level.

keep in mind that pH scale is logarithmic - each 1 increase/decrease is a 10x change in concentration - that means a drop from 7.7 to 7.4 is about a 50% decrease in the "good stuff" that pH provides to corals.

Hopefully once you increase your alk to 8-9 it will address the pH. if not, then you have other underlying problems such as high co2 content.

7.7pH should be the minimum for corals but even at those levels, most except for the hardiest stony corals and soft corals will deteriorate over a long term. Generally, 7.9 - 8.1 is the recommended "acceptable" level for stony corals and for ones that want to target the best health/growth, they maintain a pH of 8.3.

There is a right way and wrong way to address your pH problem. I'd recommend starting wit these two articles and do more research afterwards based on what may be specifically causing your pH issue.


 

Glenner’sreef

2500 Club Member
View Badges
Joined
Oct 27, 2017
Messages
3,585
Reaction score
11,095
Location
ARIZONA
Rating - 0%
0   0   0
Two small red flags for me. 1. Local fish stores usually use the cheap and often times less accurate API test. So if you can invest in a Salifert or Red Sea test kit soon. I promise you’ll have different numbers. Secondly re: salinity of 500, your salt that you use may very well be at or near that number. I know that Instant Ocean is 490 (I’m pretty sure) . Best of luck. :)
 
Back
Top