PH Control for Calcium Reactor ASAP?

[WVReefJunkie]

I have a outlet programmed If PH>6.8 Then On. The fusion programmed accepted this but the outlet has power on it with a ph reading of 6.47 in the reactor. The outlet is set to auto, any ideas?

 

[Thor2j]

I have a outlet programmed If PH>6.8 Then On. The fusion programmed accepted this but the outlet has power on it with a ph reading of 6.47 in the reactor. The outlet is set to auto, any ideas?

I'm assuming you are talking about an apex. You have to have a set off command otherwise once it turns on greater then 6.8 it wont turn off. While u are there put a fallback off as well.

Fallback OFF
Set OFF
If PH>6.8 Then ON

 

[WVReefJunkie]

The problem was that I have two ph probes and the language didn't have ph2, I got that fixed. Thanks for the other info, I'll go back in and change that. Thanks.

 

[Snook65]

Like Thor said, I believe you need an OFF statement. Here is how mine is programmed:

Fallback OFF
If pH > 6.58 Then ON
If pH < 6.53 Then OFF

 

[WVReefJunkie]

I put his language in.