PH Inside Caclicum Reactor w/out CO2

LittleMaui

Active Member
View Badges
Joined
Apr 6, 2016
Messages
452
Reaction score
151
Location
Portland, Oregon
Rating - 100%
1   0   0
I have calibrated pH probes in my tank and reactor. After topping off my media and starting everything except the CO2, I noticed the pH in the reactor is 8.8 vs. the tanks pH of 8.1. Is it normal for the pH in the reactor to be higher than the main tank?

Shawn
 
Did you use 4 and 7 solutions to calibrate the cal reactor's probe?

Or did you use 7 and 10 to calibrate both probes?

Otherwise Tagging... :)
 
Switch the probes & see what they read. It is the same tank water, should be the same I would assume, if you are not adding CO2 yet.
 
A bunch of folks have recently reported pH rises in their reactor when starting up. It goes away so just keep going.

I’m not sure what it is from, but perhaps the media was washed somehow to have high pH surface chemicals.
 
I didn't re-calibrate this time, but when I last did both probes I used 7 and 10.
It would be best to calibrate using 4 and 7 solutions for your cal reactor's probe.
 

TOP 10 Trending Threads

WHAT KIND OF REEFING DEAL ARE YOU HOPING TO PICK UP THIS BLACK FRIDAY?

  • A whole new aquarium or complete system

    Votes: 4 14.8%
  • Lighting, pumps, or other major equipment

    Votes: 4 14.8%
  • Controllers, testing, dosing, or automation gear

    Votes: 2 7.4%
  • Dry goods and restocks, like salt, media, or food

    Votes: 2 7.4%
  • Corals! Must...Have...CORALS!!!

    Votes: 7 25.9%
  • Fish or other livestock

    Votes: 1 3.7%
  • Rock, sand, or other aquascaping supplies

    Votes: 1 3.7%
  • I’m browsing, but don’t have a specific target

    Votes: 4 14.8%
  • I’m not shopping for reef deals this year

    Votes: 1 3.7%
  • Other (Post in the comments)

    Votes: 1 3.7%
Back
Top
Home
Post thread…
Market
What's new