pH probes calibration off point

BonelessEvil

Active Member
View Badges
Joined
Dec 11, 2017
Messages
154
Reaction score
45
What state or country do you live in
California
Rating - 0%
0   0   0
I've calibrated both Neptune systems and BRS brands of probes (double junction, using Apex automatic calibration). Having given up on my original Neptune systems probe, as it seemed to have a faulty cable (the reading would match my test kit, then it wouldn't, almost like a faulty cable was at play). As for the 2nd probe, the BRS (brand-new as of last week), I've not been able to get it to match the Red Sea test kit I used: BRS = 7.7, Red Sea test kit = 8.0.

What is considered a reasonable margin of error for a pH probe?
should I use manual calibration? Will that help?
Should I start over, cleaning the probe off and then calibrating? Instructions on cleaning the probe would be helpful
 
Cleaning I just use a soft toothbrush and rodi water.
Calibration I found manual works better, and log into apex.local don't to it through fusion.
 
what's the difference between fusion and apex.local in this regard?

Cleaning I just use a soft toothbrush and rodi water.
Calibration I found manual works better, and log into apex.local don't to it through fusion.
 
what's the difference between fusion and apex.local in this regard?
For some reason doing through fusion I’ve not had a solid calibration stick, doing it through apex.local I’ve alwats been dead on even weeks later.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new