pH range

  • Thread starter Thread starter Javierati
  • Start date Start date
  • Tagged users Tagged users None

Javierati

Community Member
View Badges
Joined
May 7, 2021
Messages
40
Reaction score
11
Location
Dorado
What state or country do you live in
Other International
Rating - 0%
0   0   0
I have a pH question.

I was running at 7.95 to 8.1 pH

I have a Nyos 300 with two air intakes. Thinking that CO2 is one of the main drivers of low pH I bought (2) CO2 scrubbers and connected it to the protein skimmer.

pH went from 8 to (8.3-8.42) range.

when I disconnect 1 of the CO2 scrubbers, my range becomes 8.15-8.25

What is best?
8.15-8.25 range
Vs
8.3-8.45
 
Best implies an opinion, and begs the question "What criteria?".

Higher pH is expected to lead to faster growth of some hard corals, given other conditions are not limiting growth.

Higher pH can also lead to more precipitation of calcium carbonate on pumps, etc.

The pH range of a typical reef tank is generally Ok from 7.8 to 8.55. Outside that range, issue become more concerning.

What is "perfect?". Depends on your goals.

I ran my tank at 8.30 to 8.55 for years and though that was fine.
 
Best implies an opinion, and begs the question "What criteria?".

Higher pH is expected to lead to faster growth of some hard corals, given other conditions are not limiting growth.

Higher pH can also lead to more precipitation of calcium carbonate on pumps, etc.

The pH range of a typical reef tank is generally Ok from 7.8 to 8.55. Outside that range, issue become more concerning.

What is "perfect?". Depends on your goals.

I ran my tank at 8.30 to 8.55 for years and though that was fine.
Thank you
I’ve read to aim at 8.3, but once I got there, the pH kept rising a bit to 8.4-8.42 and I got concerned it could be harmful to run the aquarium at those levels.

your post gives me reassurance that 8.3-8.4 pH is ok.
 
You will find that your corals will grow significantly faster with the higher pH. Randy is right about precipitation - I was dosing 2 part and got quite a bit of precipitation with the higher pH. Switched to a calcium reactor which does slightly lower your pH. Found nice balance between higher pH (mine tops out now at 8.35) with using calcium reactor and CO2 scrubber.
 
Last edited:
how does one get their PH to stabilize at 8.2-8.3? My PH seems to like staying at 7.8-8.0. I'd like to raise it a bit to 8.2 but not sure if I need to use a PH buffer or not
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 17.7%
  • Fish or coral food

    Votes: 5 5.2%
  • Test kits or reagents

    Votes: 10 10.4%
  • Filter media or replacement fleece

    Votes: 5 5.2%
  • RO/DI filters or supplies

    Votes: 15 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 12 12.5%
  • I keep a backup of everything

    Votes: 25 26.0%
  • Other (Post in the comments)

    Votes: 7 7.3%
Back
Top
Home
Post thread…
Market
What's new