fr3n0z
Well-Known Member
I am reading few post where PLA is not encouraged because tought not to be "reef safe", i would like to point this article... https://www.degruyter.com/document/...revealed that PLA,no degradation in the ocean. where it reports some case studies (with reference) that states that pla it does not decompose in sea water (or water in general).
Is a bit of a misconception since PLA is normally seen as biodegradable, but the process of degrading PLA requires high"ish" temperature (over 50°C) bacteria and others process. Google can explain it if someone want to look at it.
Especially for newbie, PLA is the MUST starting filament. If you want to start with ABS, you most likely will encounter problem from the beginning and must keep in mind that ABS should be printed in a enclosed case for ease of print and also for not to breath the cancerogenic fumes that release when eated.
For me, i go all PLA (and TPU if needed), is not saltwater but i have PLA impression in my freshwater for 3+ year and they not show any problem, nor the fish or inverts.
Is a bit of a misconception since PLA is normally seen as biodegradable, but the process of degrading PLA requires high"ish" temperature (over 50°C) bacteria and others process. Google can explain it if someone want to look at it.
Especially for newbie, PLA is the MUST starting filament. If you want to start with ABS, you most likely will encounter problem from the beginning and must keep in mind that ABS should be printed in a enclosed case for ease of print and also for not to breath the cancerogenic fumes that release when eated.
For me, i go all PLA (and TPU if needed), is not saltwater but i have PLA impression in my freshwater for 3+ year and they not show any problem, nor the fish or inverts.
