Hey all,
I'm designing a new stand that will slide around my sump to hold two 32 gallon Brute containers that will be used as ATO reservoirs. I plan to use the "rocket engineer" design but without one of the orange braces, on the side away from me when looking at the sump so I can slide the stand around it. The two pink braces on that side that typically meet the orange brace would extend to the floor. There will be two blue braces across the top which will land somewhere under the Brute containers. The red and yellow boards will be 2x6s with the rest being 2x4s. The dimensions will be 54 inches long, 30 inches wide, and 41 1/2 inches (overall) tall.
Are there any concerns with this design? I will skin just the top with 1/2" plywood to set the brute containers on. Below is a picture of the sump as the stand will slide around it and a "rocket engineer" design for reference. Thanks in advance!
I'm designing a new stand that will slide around my sump to hold two 32 gallon Brute containers that will be used as ATO reservoirs. I plan to use the "rocket engineer" design but without one of the orange braces, on the side away from me when looking at the sump so I can slide the stand around it. The two pink braces on that side that typically meet the orange brace would extend to the floor. There will be two blue braces across the top which will land somewhere under the Brute containers. The red and yellow boards will be 2x6s with the rest being 2x4s. The dimensions will be 54 inches long, 30 inches wide, and 41 1/2 inches (overall) tall.
Are there any concerns with this design? I will skin just the top with 1/2" plywood to set the brute containers on. Below is a picture of the sump as the stand will slide around it and a "rocket engineer" design for reference. Thanks in advance!