Power bar question

[Rrb1399]

How do I get power to the bar ? Everything is connected but I have no power so nothing turns on ?

 

[*Ruffian*]

How do I get power to the bar ? Everything is connected but I have no power so nothing turns on ?

You go into switches in ghl connect. You can assign a function for each outlet. It does need to be connected to the profilux with a pab cable.

 

[Lasse]

What you mean with now power - is not the power bar light up (if it is the new model) - is not any of the LED light up?

Sincerely Lasse

 

[Rrb1399]

It’s powered on with light I’m confused on setting the outlets up

 

[Lasse]

Connect a PAB cable between the bar and the P4

Go to this part

Press this bar

You will come to a list of devices (only 1 if you only have 1 bar, check your bar

Back

First bar . start with 1. If you want a socket to be on even if the P4 fail, check that socket

If you number it from 1 (it means that your bar have switch channels 1-6) you can go to the switch channels. I have configure my channel 5 to answer to my level indicator (top off)

In order to set the function - press the little arrow to the right

Here you can set your function - what is going to switch on or off

Hope this help a little

Sincerely Lasse

 

[Rrb1399]

Yes that was perfect !! Can I still use my Ink bird heater controller or should I just eliminate it now ?

 

[Rrb1399]

thank you !

 

[Rrb1399]

How’s she look ? I still have to do the ph and salinity and orp

 

[bdare]

How’s she look ? I still have to do the ph and salinity and orp

Make sure you have drip loops on those cords.... don't want water getting in there!