Problem with setting upp RO filter

  • Thread starter Thread starter Uluds
  • Start date Start date
  • Tagged users Tagged users None

Uluds

New Member
View Badges
Joined
Jan 3, 2024
Messages
4
Reaction score
1
Location
Sweden
Rating - 0%
0   0   0
Hey everyone

I just bought my first RO filter and have never used one before. It came with no instructions and I believe that I'm doing something wrong because the water comes out at 230 ppm even after flushing the system for 1 hour. Could someone take a look and tell me if im doing somethin obvoiusly wrong?
 
20240103_200206 (1).jpg
 
Bypass valve is open. What’s the tan container above the ro? Looks like anion.
 
Normal ro tds is about 1-3. DI gets the rest. Close the valve.
 
People in the thread nailed it - your flush valve was open.

With your flush valve open the flow of your concentrate (aka waste water) looks very limited - this would lead me to believe your feed pressure is low. Unfortunately you bought a system with no pressure gauge. Good news: a Pressure Gauge Add On Kit is not expensive.

You'll also want to orient that little inline DI cartridge so it is vertical, with flow going from the bottom to the top.

Russ
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new