Problems with Tunze Osmolator 3155 ATO

  • Thread starter Thread starter mmw64
  • Start date Start date
  • Tagged users Tagged users None
In order to stop this from happening, make sure the hose outlet is always above the water level in the ATO reservoir.
 
7E771023-B4E1-43B6-9246-8985C8B707CC.jpeg
Thanks, was thinking the high “hump” in the hose would stop a siphon.
Crude pic.
 
Hump doesn’t matter... the end of the hose relative to the level in the reservoir does! :)
 
Any ideas on fixing tunze osmolator? The sensor for filling doesn’t seem to detect that it’s dry. I wiped it with vinegar the other day and it seemed to fix it but return pump sucking air again today. Tried wiping again and it just did a couple short bursts of water then stopped. Also looks like the sensor is hardwired in the controller box so not sure if replaceable? The pump does run when I unplug and plug back the power like it’s supposed to. So I think the pump is good?
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new