Question about RO rejection rate

  • Thread starter Thread starter dantimdad
  • Start date Start date
  • Tagged users Tagged users None

dantimdad

10K Club member
View Badges
Joined
Jun 24, 2009
Messages
10,198
Reaction score
42,593
Location
Hartselle Alabama
What state or country do you live in
Alabama
Rating - 0%
0   0   0
I have used RO/DI setups for years. Last one got broken and am getting ready to setup the new one.

Where I live, the sewer bill is twice what you use in water. So, even if you fill a pond up, you pay for sewer at double the rate. So you can imagine what my bill was when I filled by 1000+ gallon pond. :(

So, my question is: Would a booster pump lower the rejection rate through my RO buddy, enough to make it worth while?

Has anyone used this particular unit with a booster pump? What was the result?

Thanks!
 
I’m not sure about the RO buddy but a booster pump can absolutely decrease rejection rates on most RO systems.
 
Increase inlet temp is best followed by pressure, also make sure to purge the membrane before each use.

You can increase the temp by coiling a long inlet tube in a tub of heaterd water.

Here’s DOW’s paper on the topic and a snapshot of the pressure and temp effect plots
DF1FC0EF-8D4F-445A-B17C-0CB8FB2EB432.png
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new