Raising PH

Ok that has a high air flow rating. Open your air flow valve all the way, if it’s not already.
If skimmer overflows you can either raise the skimmer or lower the water level. Good luck!
thanks. I'll try opening it a bit more. Water level is a bit high as I just did a water change.
 
I suggest you recirculate the scrubber by hooking the intake up to the lid of your skimmer cup. This resulted in a higher ph for me and makes the soda lime media in the scrubber last a lot longer.
I read some on this and it seems there is a risk of overflow or a mess? Not sure I'm ready for that plus I'd have to drill the top?
 
+1 on recirculating the scrubber - made all the diff in mine.

Also - it could be that the ambient CO2 in your living room is too high that's actively counteracting your scrubber due to the regular air exchange from the exposed surface areas. If that's the case consider REDUCING the surface water agitation. If you are concerned about o2 b/c the scrubber is recirculating now, you can run a second air pump with outside air directly.
Tank (79") is in a 10x10 room--my home office. I normally also have the 2 back sliders open, and sometimes the livingroom window. Even in winter. Very few days where there is no doors or windows open. Esp the office as I use window to help control humidity (do have a dehumidifier) . I can probably do with less surface agitation. While using reef flux I had more agitation. With cyano in there now I've pointed the gyres down a bit for flow to sand
 
There is a chart in the article you shared showing that the ph will rise if alkalinity rises. All things being the same. If I raise my alk from 9.5 to 10.5 with all for reef, my ph should also rise?

Yes, pH will rise at equilibrium with the same air, but only by about 0.04 pH units.
 
I read some on this and it seems there is a risk of overflow or a mess? Not sure I'm ready for that plus I'd have to drill the top?
Just don't skim super wet and it isn't an issue, especially with a larger skimmer. I know some people have put a float valve through the lid to prevent it. It hasn't been an issue for me. Yes you'd need to drill open one of the exhaust holes to attach the 3/8" line from the scrubber though. Feel free to ask if you decide to do it, it works like a charm. I understand your reticence though. Good luck with your ph!
 

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 16 30.8%
  • I’d trust someone who knows my tank to choose

    Votes: 2 3.8%
  • I’d rather get a gift card and pick it myself

    Votes: 19 36.5%
  • I’d prefer gear or supplies instead

    Votes: 0 0.0%
  • Please don’t surprise me with livestock

    Votes: 15 28.8%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new