Zgraggen Bruno
Community Member
somebody knows the dimension (metric) of the ball valve (inlet) of a RedSea Peninsula 500. Would like to change the valve.
Red Sea Peninsula 500 Valve
- Thread starter Zgraggen Bruno
- Start date
- Tagged users None
NXE
Active Member
By inlet valve, do you mean the diaphragm valve on the main drain? Assuming so, it is 32mm.
I have the same tank and replaced the stock valve with a gate valve, which is much easier to control. I will be posting the details on my build thread later today, but in essence, I cut the stock drain line halfway along and used a coupler to mate the new parts.
Here is the stock part (the black line is where I cut the pipe):
Assembling the new gate valve:
The final part:
I have the same tank and replaced the stock valve with a gate valve, which is much easier to control. I will be posting the details on my build thread later today, but in essence, I cut the stock drain line halfway along and used a coupler to mate the new parts.
Here is the stock part (the black line is where I cut the pipe):
Assembling the new gate valve:
The final part:
OP
OP
Zgraggen Bruno
Community Member
Oh thank you this is great
Similar threads
