Red Sea Reefer Chip

SinisterKestrel

New Member
View Badges
Joined
Feb 3, 2023
Messages
9
Reaction score
42
Location
Wilmington
Rating - 0%
0   0   0
Picked up this used Red Sea 250, in transport one of the corners got chipped, seems cosmetic to me but want a second opinion before I bother to leak test
20230203_162318.jpg
20230203_162310.jpg
 

Big G

captain dunsel
View Badges
Joined
Jun 8, 2017
Messages
12,921
Reaction score
27,288
Location
Southern Oregon
Rating - 0%
0   0   0
The problem with a leak test is that a brief filling of the tank appears to signal that it's just fine to use long term. The Navy studied glass fracture. Here's a brief part of the summary to ponder:

"This paper has summarized the strength and fracture data on glass,
emphasizing the phenomenon of static fatigue. In summarizing the strength of glass, it was noted that glass is characterized by extreme brittle behavior. The practical strength is much less than the theoretical strength because of the presence of cracks in the glass surface. The growth of
these cracks caused by water in the environment leads to the phenomenon of static fatigue, which is characterized by delayed failure under constant load, or a loading rate dependence of strength."
 

vetteguy53081

Well known Member and monster tank lover
View Badges
Joined
Aug 11, 2013
Messages
91,850
Reaction score
202,850
Location
Wisconsin -
Rating - 100%
13   0   0
Picked up this used Red Sea 250, in transport one of the corners got chipped, seems cosmetic to me but want a second opinion before I bother to leak test
20230203_162318.jpg
20230203_162310.jpg
This is a type of crack that under pressure may spread. Some chips are non-structural and a good risk but when they get too close to the seam- risk increases. I've repaired many tanks and this is one that is borderline if a customer bought it to me for repair.
 
OP
OP
S

SinisterKestrel

New Member
View Badges
Joined
Feb 3, 2023
Messages
9
Reaction score
42
Location
Wilmington
Rating - 0%
0   0   0
This is a type of crack that under pressure may spread. Some chips are non-structural and a good risk but when they get too close to the seam- risk increases. I've repaired many tanks and this is one that is borderline if a customer bought it to me for repair.
Is there any repair short of a full panel replacement that you would trust in this case?
 

vetteguy53081

Well known Member and monster tank lover
View Badges
Joined
Aug 11, 2013
Messages
91,850
Reaction score
202,850
Location
Wisconsin -
Rating - 100%
13   0   0
Is there any repair short of a full panel replacement that you would trust in this case?
You can check with a Reputable auto glass repair specialist which may be able to pressure repair it - the process used for window chips
 

Creating a strong bulwark: Did you consider floor support for your reef tank?

  • I put a major focus on floor support.

    Votes: 18 51.4%
  • I put minimal focus on floor support.

    Votes: 6 17.1%
  • I put no focus on floor support.

    Votes: 10 28.6%
  • Other.

    Votes: 1 2.9%
Back
Top