Red Sea Reefer stand problem?

[OriginalUserName]

Is this a problem? The end piece of the stand looks slightly bowed out and there is some gap between that piece and the horizontal piece. The tank is still level. I suppose its possible that I didn't drive the locking screws in far enough but since there were no directions I sunk them to where it looked right.

Last pic is with the door open and where you can see the gap between boards.

If I have to drain this tank and take it down I will be booking a flight to the Netherlands to pay someone a visit.

 

[Katrina71]

I wouldn't be comfortable with it.

 

[titlowda]

? My Reefer 250 doors sit in front of the sides of my cabinet. What model is it and can you take a picture from farther away?

 

[OriginalUserName]

650 peninsula

Its odd that the panel seems to bow out a little. Of course there is no middle support for the side panels, only top and bottom.

 

[PerplexyHexy]

Is this a problem? The end piece of the stand looks slightly bowed out and there is some gap between that piece and the horizontal piece. The tank is still level. I suppose its possible that I didn't drive the locking screws in far enough but since there were no directions I sunk them to where it looked right.

Last pic is with the door open and where you can see the gap between boards.

If I have to drain this tank and take it down I will be booking a flight to the Netherlands to pay someone a visit.

You have to adjust the doors... mine did the same thing... there are 2 screws on the mounting bracket... loosen middle one and adjust the back screw to creat tilt to even the door out... took me 2 days to figure that one out

 

[OriginalUserName]

You have to adjust the doors... mine did the same thing... there are 2 screws on the mounting bracket... loosen middle one and adjust the back screw to creat tilt to even the door out... took me 2 days to figure that one out

I adjusted them a bit already. The inconsistent gap is what worried me. Not a major deflection either way but ill send some pics to red sea just in case.

 

[PerplexyHexy]

Never really knew that most cabinets have those till I found out about that little gem...

 

[PerplexyHexy]

Do not take the brackets off... they are completely fine... just fine tune it

 

[PerplexyHexy]

Im sure they will be as worried with your issue as they were mine...