repair coral viewer

Jimmyneptune

Active Member
View Badges
Joined
Jan 29, 2017
Messages
429
Reaction score
275
Location
Chicago
Rating - 0%
0   0   0
I have a sea side aquatics coral viewer that has a slow leak. the viewer starts to fill up with water over 15-30 minutes when floating on the water. What can I use to repair the coral viewer?
 
I would take a thin layer of clear silicone and seal the side that goes into the water. Just be sure not to get a lot of silicone on the clear plastic. You could seal it from the inside too. Be sure not to put it into the water until the salt and vinegar smell is no longer present.
 
A couple drops of the right Weld On # or a similar solvent adhesive applied heat the seam should seal it right up. Silicone will look like a hack and may or may not stick long term. Use some citric acid and an RO rinse before the solvent though. You want to get any salt or calcium buildup out of the leak path so it can be filled.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new