RO/DI Beginner Question

  • Thread starter Thread starter Misbar
  • Start date Start date
  • Tagged users Tagged users None

Misbar

Active Member
View Badges
Joined
Aug 1, 2019
Messages
112
Reaction score
87
Location
Pennsylvania, USA
What state or country do you live in
Pennsylvania
Rating - 0%
0   0   0
Hello,

After reading through some articles/websites, it seems that optimum psi for an ro/di system is 50-80psi. With that said, my holding tank is rated at 38 psi, and as soon as it begins to empty the pressure drops to 30psi. What would happen if I tried to use an ro/di system with this low pressure? Could I get away with 30psi? If not, what is the most affordable way to solve this problem?

Thank you for your time,

Misbar
 
While you can use 30PSI your RODI filter will not run anywhere near as efficient as it should. Lower water pressure means less pressure forcing water through the RO membrane itself. This means it won't be performing at it's best and you will be sending more water down your drain than you should. The best and cheapest way to rectify this issue is a booster pump. These cost around $150ish and should be installed after the sediment and carbon blocks but before the membrane.

https://www.bulkreefsupply.com/1-4-aquatec-8800-booster-pump-kit.html
 
Thanks guys I appreciate it. It is indeed well water.

I don't like the idea of wasting even more water, so I guess I will grab a booster pump while its on sale.

Thanks again,

Misbar
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new