- Joined
- Jun 16, 2019
- Messages
- 272
- Reaction score
- 117
Hey just wondering if I could get a sanity check on my planned ro system — main thing is I want to be able to pump RODi into the salt container without risk of getting salt in the rodi container (I.e., use two separate pumps as I know I would turn the wrong valve one time and flood my RODi with salt water if the containers shared pumps)
I’m planning to use a norwesco 105 gallon reservoir for the RODi water and a norwesco 55 gallon container for the salt water (this literally uses every possible Inch in my closet)
thinking since I don’t have room for two 105 containers I should make the salt water container smaller so that there is always rodi available for mixing salt.
also planning on doing kalk, auto water changes and two ato’s for redundancy.
Note: planning on using an external pump on the salt mixing container since the top opening is so small that I couldn’t fit a powerful enough pump in there.
Note: the “3 way valves” may end up being two ball valves in series — apparently 3 way valves are hard to find / expensive for some reason. Just want to be able to pump only RODi or only salt as needed.
I’m planning to use a norwesco 105 gallon reservoir for the RODi water and a norwesco 55 gallon container for the salt water (this literally uses every possible Inch in my closet)
thinking since I don’t have room for two 105 containers I should make the salt water container smaller so that there is always rodi available for mixing salt.
also planning on doing kalk, auto water changes and two ato’s for redundancy.
Note: planning on using an external pump on the salt mixing container since the top opening is so small that I couldn’t fit a powerful enough pump in there.
Note: the “3 way valves” may end up being two ball valves in series — apparently 3 way valves are hard to find / expensive for some reason. Just want to be able to pump only RODi or only salt as needed.
Last edited: