If you have an RODI unit, it scrubs the Chlorine out already when it goes through the carbon part of the filter. The 4 TDS means you have only 4ppm solids left, which leaves little of anything. I would check whether the TDS meter is set up properly, it should be after the DI unit, so you know that you're getting near zero (usually zero) after the DI stage. Typically I'd have it After the RO unit (~4 ppm) and then after the DI (0 ppm). You'll probably always be within the ballpark of that 159 number coming out of the tap, so not a huge reason to check it. But you will want to flush the RO membrane for a minute or so to get that TDS creep out if possible so you're not burning through DI resin.