RowaPhos questions -

BanjoBandito

Valuable Member
View Badges
Joined
Jul 24, 2018
Messages
2,300
Reaction score
2,812
Location
Butler County, PA
What state or country do you live in
Pennsylvania
Rating - 0%
0   0   0
I'm using RowaPhos in my reactor...but I have a question - it's "escaping" my foam inserts due to it's size, does anyone sell smaller celled foam inserts for it? I use an IO minimax. Or can I just cut some cheesecloth and make it work?

Also - is RowaPhos considered GFO (slow removal) or is it more rapid like PhosGuard? Thanks.
 
RowaPhos is faster than Phosgurad, you should use wool filter floss, Sera makes. some, or use Filter Floss from Micheals, use top and bottom of the Rowa.
 
Careful rowaphos is really strong. If you don’t monitor or use too much you could end up like me dosing phosphates back into the tank
 
Careful rowaphos is really strong. If you don’t monitor or use too much you could end up like me dosing phosphates back into the tank
Basically what happened. My phosphates in my nano have consistently been high (.2+) and I'm not getting good growth out of my SPS, so I'm trying to get things in "balance". I got a media reactor and ran PhosGuard for less than 24 hours and was at 0.0. So I'm trying to find a "gentle way" to get me back to around .7 - .1 consistently. I don't dose phosphates, I just use reef roids, the ultimate in phosphate bombs.
 
easiest way I found was just to have a valve to lessen the flow til my phosphates were steady where I wanted them. Was better for me than trying to find a schedule on how long to run it. I’m using a very small amount as it is.
 
easiest way I found was just to have a valve to lessen the flow til my phosphates were steady where I wanted them. Was better for me than trying to find a schedule on how long to run it. I’m using a very small amount as it is.
I have a IM minimax, it has a flow controller on the media tube and the pump itself, I got a lot of tinkering to do that's for sure. It's comical to think I need to run a tablespoon of media, but it's the only way I can keep phosphates under control without dosing lanthum daily or other extreme measures.
 
Basically what happened. My phosphates in my nano have consistently been high (.2+) and I'm not getting good growth out of my SPS, so I'm trying to get things in "balance". I got a media reactor and ran PhosGuard for less than 24 hours and was at 0.0. So I'm trying to find a "gentle way" to get me back to around .7 - .1 consistently. I don't dose phosphates, I just use reef roids, the ultimate in phosphate bombs.
If you don't see good results from reef roids, try to mix it up. Oyster eggs one day, aminos another, phyto, marine snow, lots of choices.
I stopped reef roids regularly to their phosphates.
 
If you don't see good results from reef roids, try to mix it up. Oyster eggs one day, aminos another, phyto, marine snow, lots of choices.
I stopped reef roids regularly to their phosphates.
I’ve been considering going back to phyto as well. Many benefits there
 
If you don't see good results from reef roids, try to mix it up. Oyster eggs one day, aminos another, phyto, marine snow, lots of choices.
I stopped reef roids regularly to their phosphates.
I guess what I meant was when my phosphates are low or "double zero" I dose reef roids as a phosphate supplement.
 
I guess what I meant was when my phosphates are low or "double zero" I dose reef roids as a phosphate supplement.
I’ve done it too, works better then neophos in my tank hahah neophos would get used up right away, where reef roids kept phosphates around a bit longer
 
Place in a nylon stocking to contain it inside the reactor
 

WHAT’S USUALLY THE FIRST CLUE THAT SOMETHING IS OFF IN YOUR REEF?

  • A fish’s behavior or appetite changes

    Votes: 10 14.3%
  • A coral looks different or stops opening normally

    Votes: 44 62.9%
  • Water clarity or surface appearance changes

    Votes: 10 14.3%
  • Equipment sounds or flow seem different

    Votes: 7 10.0%
  • A test result catches my attention

    Votes: 14 20.0%
  • Algae or other growth starts changing

    Votes: 14 20.0%
  • I usually notice when the problem is already obvious

    Votes: 3 4.3%
  • It depends on what’s going on

    Votes: 13 18.6%
  • Other (Post in the comments)

    Votes: 1 1.4%
Back
Top
Home
Post thread…
Market
What's new