RSCP salt has turned white.

NewbieReefer11

Active Member
View Badges
Joined
Feb 22, 2018
Messages
200
Reaction score
145
What state or country do you live in
Australia
Rating - 0%
0   0   0
Hi everyone I just setup my new saltwater mixing station. I tried to make my first batch and it has turned white. Can I still use it?
If I turn the pump off the water pretty much clears but there is white stuff t the bottom. Is this ok?

Thanks
 
If the water turned white...
Do you have a heater in it and set for your display tank temp ?
Sounds like the slat needs to be dissolved more with a powerhead
 
If the water turned white...
Do you have a heater in it and set for your display tank temp ?
Sounds like the slat needs to be dissolved more with a powerhead
No the water isn't heated however I live in Australia and it's been 25 to 30 Celcius for a few days
 
No the water isn't heated however I live in Australia and it's been 25 to 30 Celcius for a few days
I’d try a heater. And make sure your pump for mixing is over 500gph
 
it precipitation. something happened. either the salt elements settled improperly or water was not right temp. if you tested the newly mixed water your alk and cal will be way off and low. you can use it but its chemistry will be off.

Did you add salt to water or water to salt?

water could also be rich in CO2 which will cause precipitation. like well water or non aerated non circulation/ sitting still water for long periods of time.etc

25 to 30c is 77 to 86F. most saltmix need to be within 76-78F and i have seen precipitation happening in hotter water temp specially it it was 86F.

Also could be just calcium carbonate that needs place to settle. if this is the case then no need to worry.
But my guess will be water temp too hot and carbonate precipitation.
 
Last edited:
it precipitation. something happened. either the salt elements settled improperly or water was not right temp. if you tested the newly mixed water your alk and cal will be way off and low. you can use it but its chemistry will be off.

Did you add salt to water or water to salt?

water could also be rich in CO2 which will cause precipitation. like well water or non aerated non circulation/ sitting still water for long periods of time.etc

25 to 30c is 77 to 86F. most saltmix need to be within 76-78F and i have seen precipitation happening in hotter water temp specially it it was 86F.

Also could be just calcium carbonate that needs place to settle. if this is the case then no need to worry.
But my guess will be water temp too hot and carbonate precipitation.
I added salt to water however I did half one day and half the next.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 15 18.1%
  • Fish or coral food

    Votes: 5 6.0%
  • Test kits or reagents

    Votes: 8 9.6%
  • Filter media or replacement fleece

    Votes: 4 4.8%
  • RO/DI filters or supplies

    Votes: 13 15.7%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 12.0%
  • I keep a backup of everything

    Votes: 21 25.3%
  • Other (Post in the comments)

    Votes: 7 8.4%
Back
Top
Home
Post thread…
Market
What's new