I want one for an aquavitro salinity bucket...
Is that you getting rid of stuff on FB?
I don't FB so prob not...
His name was Sean Clark but I thought I remembered you not doing social media so I didn't comment on his post.
If you can sketch a cross-section of the lip and add measurements and take a measurement of the inside and outside bucket Dimensions I can modify the design.
Can do. I will get you some super shady measurements in the AM after coffee. The latching element on the lip is the only issue I see. A wider "gap" on the sock holder is all I think that it would need.
Do you still have the lid?
I have the StinkSink - it seems to work good except my skimmer cup over foams and the vent holes always have skimmate bubbling out.
You know how you kill the foam in your beer? do the same with the rim of your skimmer cup. I found if you put some ear/nose/olive oil on the rim it foams less. I added a 1/2" air-gap between the carbon and the skimmer but its not enough without the oil trick.
Adjust that white balance! :zany-face:
At the in-laws in VT… really digging the WYZE camera! So far so good! Helps that I’m not too concerned about killing corals!
Don’t know how! Will have to read on it
