Sfin's Dream.

I think most of these pumps are designed to run the length not the width of the tank.
I think they're just designed to move water in a laminar sheet. If this was an SPS tank, It wouldn't be enough flow. Given that it is LPS dominated, it's too much for the intended use.
 
I think they're just designed to move water in a laminar sheet. If this was an SPS tank, It wouldn't be enough flow. Given that it is LPS dominated, it's too much for the intended use.
I have the same gyre for length of my 75/80 and it’s on lowest and I think it’s too much haha need to get another on other side to offset it
 
I have the same gyre for length of my 75/80 and it’s on lowest and I think it’s too much haha need to get another on other side to offset it
So the jebao cp 90 seems too much for a 75/90. That helps a lot thanks
 
So the jebao cp 90 seems too much for a 75/90. That helps a lot thanks
Yea alone I think it’s too much , it needs another wave maker on opposite going against it to weaken flow / disrupt. Sadly I can’t make my return pump higher otherwise it becomes too noisy , I’ll probly pair it with the ow-25
 
Yea alone I think it’s too much , it needs another wave maker on opposite going against it to weaken flow / disrupt. Sadly I can’t make my return pump higher otherwise it becomes too noisy , I’ll probly pair it with the ow-25
I get that.
 
20220507_143920.jpg
20220507_143816.jpg
 
Looks like you might need a bigger grill for those things :grinning-squinting-face:;)
The smoker was a father's day gift I make it work. I could roll them up and tie them works really well but I was to lazy
 

TOP 10 Trending Threads

Back
Top
Home
Post thread…
Market
What's new