skimmer not producing bubbles

  • Thread starter Thread starter Octane13
  • Start date Start date
  • Tagged users Tagged users None

Octane13

Active Member
View Badges
Joined
Jan 12, 2018
Messages
251
Reaction score
220
What state or country do you live in
Connecticut
Rating - 0%
0   0   0
Like the title states my skimmer recently decided it just wants to pump water. Came home one day and it was making a surging noise with very little bubbles. I suspected initially that there was something in the needle wheel. Took the skimmer apart and cleaned it completely but found nothing. For about a day or two it skimmed normally but returned to not producing bubbles. Pulled it apart again finding a tiny bit of algae on the wheel. Returned it to the sump and it operated normally, I dismissed and assumed the algae was the culprit. This time after doing a water change it went back to surging and pumping water (doesn't overflow just little to no bubbles). Suspect now that the pump is not spinning fast enough to produce bubbles as sometimes if I just cycle power it will operate "normally" for a while. Anyone have any suggestions? Skimmer is a Curve 5 about 1.5 yrs old. I put my curve 7 elite in for a few days and it worked perfect (extreme overkill for a 40br) but did produce bubbles with nice skim-mate.
 
Sounds like air passage is blocked. The most common area for this to happen is where it attaches to pump input
 
My suggestion is to check the air intake hose on the side of the skimmer. Also, check to make sure the water isn’t too low in the sump. This happened with a vertex skimmer I had and those are the things Vertex told me to check. Turned out the impeller needed replacing.
 
Turned out the impeller needed replacing.
I know the water level is good, doesn't change and hasn't since I started. Was your impeller noticeably damaged? Wouldn't think they would wear out unless a snail or some significant debris got in there. Did vertex suggest replacing it?
 
I know the water level is good, doesn't change and hasn't since I started. Was your impeller noticeably damaged? Wouldn't think they would wear out unless a snail or some significant debris got in there. Did vertex suggest replacing it?
I did have a snail I think. It had a small gauge in it.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new