Smart ATO Setup

  • Thread starter Thread starter droidus
  • Start date Start date
  • Tagged users Tagged users None

droidus

Active Member
View Badges
Joined
Jun 2, 2018
Messages
285
Reaction score
50
What state or country do you live in
Maryland
Rating - 0%
0   0   0
I have a smart ato device to maintain my water level in my biocube 32g tank. I use the lid that comes with the tank. I know my setup is not very nice, and I wish there was a better, cleaner way to do this.
I've had to prob open the lid due to the water temp getting to about 82 degrees. I would appreciate thoughts and feedback on my setup.

Edit: Also, how is my water level? I am not sure how high to put it. I want to allow for air circulation, but yet don't want it to be too low.

20180820_174237.jpg
20180820_174306.jpg
duct_tape_upload.png
 
Do you use the sight glass on the left hand side of the tank? It has a min/max for your water level. Just fyi if you didn't notice it. Your ato is much nicer than my solo cup. ;)
 
Do you use the sight glass on the left hand side of the tank? It has a min/max for your water level. Just fyi if you didn't notice it. Your ato is much nicer than my solo cup. ;)
Not sure if I'm looking at the right thing, but I only see MIN.

20180820_202516.jpg
 
You are looking at the right thing, I try not to let mine get below the middle of the window, max is at the top of the window.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new