Sps calcium

You likely have an extremely low load then. Probably don’t need dosing except for the occasional testing and correction. But if your original question is, “is more calcium better”? No, around 420 is the best number.
 
Just don’t add it. It’s not going to hurt anything being that high. Just don’t add calcium until it lowers. Which means don’t use a balanced additive like kalkwasser or a calcium reactor. Avoid high calcium salts like Kent marine
 
So how do I lower it then. I have not added calcium in over few weeks.

What salt mix are you using? Some will mix a lot higher at 1.026 than others. And where’s your alk and mg levels? If your mg and alk are in line and things are growing fine you are likely okay.
 
Personally I wouldn't do anything to reduce. You are on the high end of cal. As load increases cal will decrease.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 11 16.4%
  • Fish or coral food

    Votes: 4 6.0%
  • Test kits or reagents

    Votes: 5 7.5%
  • Filter media or replacement fleece

    Votes: 4 6.0%
  • RO/DI filters or supplies

    Votes: 11 16.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 8 11.9%
  • I keep a backup of everything

    Votes: 18 26.9%
  • Other (Post in the comments)

    Votes: 6 9.0%
Back
Top
Home
Post thread…
Market
What's new